Enter/Exit Programming Mode Stop Bits
20
Cobalto™ CO5300 Scanner
Baud Rate — continued
Stop Bits
The stop bit(s) at the end of each transmitted character marks the end of transmission of one
character and prepares the receiving device for the next character in the serial data stream.
The number of stop bits selected (one or two) depends on the number the receiving terminal is
programmed to accommodate. Set the number of stop bits to match host device
requirements.
DEFAULT
$CR2BA04
Baud Rate = 19,200
$CR2BA05
Baud Rate = 38,400
$CR2BA06
Baud Rate = 57,600
$CR2BA07
Baud Rate = 115,200
$CR2ST00
1 Stop Bit
$CR2ST01
2 Stop Bits
To Next Page
Loading...
Need help?
General
