Customizing Configuration Settings
Product Reference Guide
13
Resetting the Product Configuration to Defaults
If you aren't sure what programming options are in your scanner, or you've changed some
options and want to restore the Custom Default Configuration that may have been saved in
the scanner, scan the Restore Custom Default Configuration bar code below. This will restore
the custom configuration for the
currently active interface.
NOTE
Restore Custom Default Configuration
Custom defaults are based on the interface type. Configure the scanner for the
correct interface before scanning this label.
If you aren't sure what programming options are in your scanner, or you've changed some
options and want to restore the Factory Configuration, you have two options. You can scan the
Restore USA Factory Configuration bar code or the Restore EU Factory Configuration bar code
below. Both labels restore the scanner configuration to the factory settings including the
in
terface type. The USA label restores Label IDs to those historically used in the USA. The EU
label restores Label IDs to those historically used in Europe. The Label ID sets for USA and EU
are shown in the Label ID section of this manual.
CAUTION
Restore USA Factory Configuration
Restore EU Factory Configuration
Scanning either of the “Restore Factory Configuration” commands below will
result in the loss of any custom configuration settings for your device.
The programming section on the following pages lists the factory default settings for each of
the menu commands (indicated by shaded blocks and bold text).
To Next Page
Loading...
Need help?
General
