GS1 DataBar
TM
Expanded Enter/Exit Programming Mode
Product Reference Guide
103
GS1 DataBar Expanded Length Control
This feature specifies either variable length decoding or fixed length decoding for the GS1
DataBar Expanded symbology.
Variable Length —
For variable-length decoding, a minimum length may be set.
Fixed Length —
For fixed-length decoding, two different lengths may be set.
DEFAULT
GS1 DataBar Expanded Length Control = Variable
Length
GS1 DataBar Expanded Length Control = Fixed Length
GS1 DataBar Expanded Set Length 1
This feature specifies one of the bar code lengths for GS1 DataBar Expanded Length
Control
. Length 1 is the minimum label length if in Variable Length Mode, or the first fixed
length if in
Fixed Length Mode. Length includes the bar code’s data characters only.
The length can be set from 1 to 74 characters. See
"Set Length 1" on page 239 for more
detailed programming instructions.
Select GS1 DataBar Expanded
Set Length 1 Setting
To configure this feature, scan the ENTER/EXIT bar
cod
e above, then the bar code at left followed by dig-
its from the Alphanumeric characters in
Appendix D,
Keypad
representing your desired character(s). End
by scanning the ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code
to abort
and not save the entry string. You can then start
again at the beginning.
CANCEL
DEFAULT
01 = Length 1 is 1 Character
$CXBLC00
$CXBLC01
$CXBL1
~
To Next Page
Loading...
