Product Reference Guide
271
Appendix E
Scancode Tables
Control Character Emulation
Control character emulation selects from different scancode tables as listed in this
appendix. Each of the control character sets below are detailed by interface type in the
tables. These apply to Wedge and USB Keyboard platforms.
Control Character 00 —
Characters from 00 to 0x1F are sent as control character
Ctrl+Keys, special keys are located from 0x80 to 0xA1.
Control Character 01 —
Characters from 00 to 0x1F are sent as control character Ctrl+Cap-
ital Key, special keys are located from 0x80 to 0xA1.
Control Character 02 —
Special keys are located from 00 to 0x1F and characters from 0x80
to 0xFE are intended as an extended ASCII table (Microsoft Windows Codepage 1252
—
see page 276).
To Next Page
Loading...
