Enter/Exit Programming Mode Interleaved 2 of 5 (I 2 of 5)
138
Cobalto™ CO5300 Scanner
I 2 of 5 Set Length 2
This feature specifies one of the bar code lengths for I 2 of 5 Length Control. Length 2 is the
maximum label length if in
Variable Length Mode, or the second fixed length if in Fixed
Length
Mode. The length includes the bar code’s check and data characters.
The length can be set from 2 to 50 characters. A setting of 0 specifies to ignore this length
(on
ly one fixed length). See
"Set Length 2" on page 241 for more detailed programming
instructions.
Select I 2 of 5 Length 2 Setting
To configure this feature, scan the ENTER/EXIT bar
cod
e above, then the bar code at left followed by dig-
its from the Alphanumeric characters in
Appendix D,
Keypad
representing your desired character(s). End
by scanning the ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code
to abort
and not save the entry string. You can then start
again at the beginning.
CANCEL
DEFAULT
50 = Length 2 is 50 Characters
I 2 of 5 Zero Pattern
Enables/disables ZERO-Digit decoding. This character does not represent any cipher. It allows
encoding of an odd number of ciphers with Interleaved 2 of 5. It must be enabled to decode
Code 2 of 5 CIP/HR.
DEFAULT
I 2 of 5 Zero Pattern = Disable
I 2 of 5 Zero Pattern = Enable
$CI2L2
~
$CI2ZP00
$CI2ZP01
To Next Page
Loading...
Need help?
General
