Enter/Exit Programming Mode ACK NAK Options
26
Cobalto™ CO5300 Scanner
ACK Character
This setting specifies an ASCII character or hex value to be used as the ACK character. ASCII
characters or any hex value from 0 to 0xFF can be selected. See
"ACK Character" on
page 220
for more detailed programming instructions.
NOTE
Select ACK Character Setting
DEFAULT
Setting to previously defined characters such as XON, XOFF, or host
commands conflicts with normal operation of these characters. 8-bit
data is not recognized when the option
Stop Bits
has been set as 7
Data Bits.
NAK Character
This setting specifies an ASCII character or hex value to be used as the NAK character. ASCII
characters or any hex value from 0 to 0xFF can be selected. See
"NAK Character" on
page 221
for more detailed programming instructions.
NOTE
Select NAK Character Setting
DEFAULT
Setting to previously defined characters such as XON, XOFF, or host
commands conflicts with normal operation of these characters. 8-bit
data is not recognized when the option
Stop Bits
has been set as 7
Data Bits.
$CR2AC
$CR2NA
To Next Page
Loading...
Need help?
General
