Datalogic Cobalto C05300 - Beep on ASCII BEL; Beep on Not on File

Enter/Exit Programming Mode Beep On ASCII BEL
24 Cobalto™ CO5300 Scanner
Beep On ASCII BEL
When this parameter is enabled, the scanner issues a beep when a <BEL> character is
detected on the RS-232 serial line. <BEL> is issued to gain a user's attention to an illegal entry
or other important event.
Beep On ASCII BEL = Disable
DEFAULT
Beep On ASCII BEL = Enable
Beep On Not on File
This option enables/disables the action of the scanner to sound a three beep sequence upon
receiving a Not-On-File (NOF) host command.
Beep On Not On File = Disable
DEFAULT
Beep On Not On File = Enable
$CR2BB00

$CR2BB01
$CBPNF00
$CBPNF01