Datalogic Cobalto C05300 - Select Audio Jingle for Power-Up Event

Enter/Exit Programming Mode Select Audio Jingle for Power-up Event
68 Cobalto™ CO5300 Scanner
Select Audio Jingle for Power-up Event
This parameter selects which preloaded Jingle
1
to use in indicating scanner power-up.
NOTE
The previous option, Audio Jingle Enable , must be enabled for this selection
to take effect.
After uploading up to fifteen (15) Jingles to the scanner using the Aladdin
TM
configuration
utility, use this setting to designate which of the Jingles (1-15) or the built-in Jingle will be
sounded to indicate scanner power-up. The built-in Jingle for power-up is Dialtone.wav.
DEFAULT
Audio Jingle on Power-up = Use built-in power-up Jingle
Audio Jingle on Power-up = Jingle #1
Audio Jingle on Power-up = Jingle #2
Audio Jingle on Power-up = Jingle #3
Audio Jingle on Power-up = Jingle #4
Audio Jingle on Power-up = Jingle #5
1. A “Jingle” is a short, user-defined tune uploaded via Datalogic Aladdin™ configuration software.
$CAUPW00
$CAUPW01
$CAUPW02
$CAUPW03
$CAUPW04
$CAUPW05