Code 39 Enter/Exit Programming Mode
Product Reference Guide
115
Code 39 Set Length 1
This feature specifies one of the bar code lengths for Code 39 Length Control. Length 1 is the
minimum label length if in
Variable Length Mode, or the first fixed length if in Fixed Length
Mode. Length includes the bar code’s check, dat
a, and full-ASCII shift characters. The length
does not include start/stop characters.
The length can be set from 0 to 50 characters. See
"Set Length 1" on page 239 for more
detailed programming instructions.
Select Code 39 Set Length 1 Setting
To configure this feature, scan the ENTER/EXIT bar
cod
e above, then the bar code at left followed by dig-
its from the Alphanumeric characters in
Appendix D,
Keypad
representing your desired character(s). End
by scanning the ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code
to abort
and not save the entry string. You can then start
again at the beginning.
CANCEL
DEFAULT
02 = Length 1 is 2 Characters
$CC3L1
~
To Next Page
Loading...
