Setup
12
Cobalto™ CO5300 Scanner
Interface Settings
The scanner is typically factory-configured with a set of default features standard to the
interface type you ordered. See Interface Selection on page 8.
Global Interface Features, starting on page 17 provides settings configurable by all interface
types. If your installation requir
es you to further customize your scanner, you can select other
options through use of the instructions and programming bar codes available in the
appropriate section for your interface.
• RS-232 ONLY Interface, starting on page 19
• RS-232/USB-COM Interfaces, starting on page 23
• Keyboard Interface, starting on page 33
• USB-OEM Interface, starting on page 43
Configuring Other Features
If your installation requires different programming than the standard factory default settings,
the following sections of this manual allow configuration of non-interface-specific settings
you might require:
Configuration Using Bar Codes —
General Features includes programming for scanning,
speaker and LED indicators and other such universal settings.
Reading Parameters —
Reading Parameters include programming for scanning, speaker and
LED indicators and other universal settings.
Symbologies —
Includes options concerning the bar code label types (symbologies). These
settings allow you to enable/disable symbologies, set label lengths, require check digit, etc.
Software Version Transmission
The software version of the device can be transmitted over the RS-232, Keyboard and USB
interfaces by scanning the following label.
Transmit Software Version
RevA
To Next Page
Loading...
Need help?
General
