Datalogic Cobalto C05300 User Manual

Enable Character Enter/Exit Programming Mode
Product Reference Guide 31
Enable Character
Specifies the value of the RS-232 host command used to enable the scanner.
ASCII characters or any hex value from 0 to 0xFF can be
selected. See "Enable Character" on
page 225
for more detailed programming instructions
NOTE
Select Enable Character Setting
DEFAULT
0x45 = Enable Character is ‘E’
Setting to previously defined characters such as XON, XOFF, or host
commands conflicts with normal operation of these characters.
.
$CR2EC

Datalogic Cobalto C05300 Specifications

General

Brand	Datalogic
Model	Cobalto C05300
Category	Barcode Reader
Language	English