Code 93 Enter/Exit Programming Mode
Product Reference Guide
191
Code 93 Set Length 2
This feature specifies one of the bar code lengths for Code 93 Length Control. Length 2 is the
maximum label length if in
Variable Length Mode, or the second fixed length if in Fixed
Length
Mode. Length includes the bar code’s check, data, and full-ASCII shift characters. The
length does not include start/stop charac
ters.
The length can be set from 1 to 50 characters. A setting of 00 specifies to ignore this length
(on
ly one fixed length). See
"Set Length 2" on page 241 for more detailed programming
instructions.
Select Code 93 Length 2 Setting
To configure this feature, scan the ENTER/EXIT bar
cod
e above, then the bar code at left followed by dig-
its from the Alphanumeric characters in
Appendix D,
Keypad
representing your desired character(s). End
by scanning the ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code
to abort
and not save the entry string. You can then start
again at the beginning.
CANCEL
DEFAULT
50 = Length 2 is 50 Characters
$CC9L2
~
To Next Page
Loading...
