Enter/Exit Programming Mode Global Prefix/Suffix
46
Cobalto™ CO5300 Scanner
Global Prefix/Suffix
Up to 20 ASCII characters may be added as a prefix (in a position before the bar code data) and/
or as a suffix (in a position following the bar code data). See
"Global Prefix/Suffix" on
page 229 for more detailed programming instructions.
To configure this feature, scan the ENTER/EXIT bar code above,
then the bar code at left followed by digits from the Alphanu-
meric characters in
Appendix D, Keypad
representing your
desired character(s). End by scanning the ENTER/EXIT bar code
ag
ain.
Set Global Prefix
Set Global Suffix
To configure this feature, scan the ENTER/EXIT bar code above,
then the bar code at left followed by digits from the Alphanu-
meric characters in
Appendix D, Keypad
representing your
desired character(s). End by scanning the ENTER/EXIT bar code
again.
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start again
at the beginning.
CANCEL
DEFAULT
No Global Prefix
Global Suffix = 0x0D(CR)
$CLFPR
$CLFSU
~
To Next Page
Loading...
