Enter/Exit Programming Mode Select Audio Jingle for Good Read Event
70
Cobalto™ CO5300 Scanner
Select Audio Jingle for Power-up Event — cont.
Select Audio Jingle for Good Read Event
This parameter selects which preloaded Jingle
1
to use in indicating a good read event.
NOTE
The previous option,
Audio Jingle Enable on page 67
, must be enabled for
this selection to take effect.
After uploading up to fifteen (15) Jingles to the scanner using the Aladdin
TM
configuration
utility, use this setting to designate which of the Jingles (1-15) will be sounded when the
scanner performs a good read.
Audio Jingle on Good Read = Use built-in Good Read
Jingle (Shutter.wav)
Audio Jingle on Good Read =
Jingle #1
$CAUPW0D
Audio Jingle on Power-up = Jingle #13
$CAUPW0E
Audio Jingle on Power-up = Jingle #14
$CAUPW0F
Audio Jingle on Power-up = Jingle #15
1. A “Jingle” is a short, user-defined tune uploaded via Datalogic Aladdin™ configuration software.
$CAUGR00
$CAGRW01
To Next Page
Loading...
Need help?
General
