Datalogic DSM0400 - GS1 Databar Expanded Set Length 2

Enter/Exit Programming Mode
146 DSM0400 Fixed Mount Area Imager Bar Code Reader
GS1 DataBar™ Expanded Set Length 2
This feature specifies one of the barcode lengths for GS1 DataBar™ Expanded
Length Control on page 144
. Length 2 is the maximum label length if in Variable
Length on page 93
Mode, or the second fixed length if in Fixed Length on page 93
Mode. Length includes the barcode’s data c
haracters only. The length can be
set from 1 to 74 characters. A setting of 0 specifies to ignore this length (only
one fixed length). For more detailed programming instructions see, "Set
Length" on
Chapter 4, References .
Table 18 provides examples for setting Length 2.
Table 18. GS1 DataBar™ Expanded Length 2 Setting Examples
STEP ACTION EXAMPLES
1 Desired Setting
00 (ignore sec-
ond length)
07 Characters 52 Characters 74 Characters
2 Scan ENTER/EXIT PROGRAMMING MODE
3 Scan SELECT GS1 DataBar™ EXPANDED LEN
GTH 2 SETTING
4
Scan Two Characters From
Appendix C
‘0’ and ‘0’ ‘0’ and ‘7’ ‘5’ and ‘2’ ‘7’ and ‘4’
5 Scan ENTER/EXIT PROGRAMMING MODE
Select GS1 DataBar™ Expanded Set Length 2 Setting
Make a mistake? Scan the CANCEL barcode to abort and
not save the entry string. You can then start again at the
beginning.
CANCEL
DEFAULT
74 = Length 2 is 74 Characters