Enter/Exit Programming Mode
Product Reference Guide 47
Keyboard Numeric Keypad
This feature specifies if numeric characters will be sent using the standard keys
or the numeric keypad
.
DEFAULT
Keyboard Numeric Keypad = Standard Keys
Keyboard Numeric Keypad = Numeric Keypad
Keyboard Send Control Characters
This feature is used by USB Keyboard only interface. It specifies how the scan-
ner transmits ASCII control characters to the host.
Options are as follows:
Send Ctrl+Key .
ASCII characters from 00H to 0x1FH inclusive are transmitted in
the format Ctrl+Key. Special keys are available in the range from 81H to A1.
Send Ctrl+Shift+Key .
The behavior is the same as above, but control keys are
sent in the format Ctrl+Shift+Keys.
Send Special Function Key .
Send characters between 00H and 1FH according to
the special function key mapping table. This is used to send keys that are not in
the normal ASCII set. A unique set is provided for each available scancode set.
DEFAULT
Keyboard Send Control Characters = Send Ctrl+Key
Keyboard Send Control Characters = Send Ctrl+Shift+Key
Keyboard Send Control Characters = Send Special Function Key
To Next Page
Loading...
Need help?
General
