Enter/Exit Programming Mode
196 DSM0400 Fixed Mount Area Imager Bar Code Reader
Micro PDF417 Set Length 1
Specifies one of the bar code lengths for Micro PDF417. Length 1 is the mini-
mum label length if in Va
riable Length Mode, or the first fixed length if in Fixed
Length Mode. Length includes the bar code’s data characters only. Characters
can be set from 0001 to 0366 characters (pad with zeroes) in increments of 01.
Any value greater than 0366 will be considered to be 0366. Always use four
digits (e.g.: scan the barcodes '0', '0', '0', '2' for setting length = 2). For more
detailed programming instructions see, "Set Length" on
Chapter 4, References
.
Select Micro PDF417 Length 1 Setting
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code at
left followe
d by the digits from the Alphanumeric char-
acters in
Appendix C
representing your desired charac-
ter(s). End by scanning the ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort and
not save
the entry string. You can then start again at the
beginning.
CANCEL
0001 = Length 1 is 1 Character
To Next Page
Loading...
Need help?
General
