Enter/Exit Programming Mode
Product Reference Guide 181
DotCode Set Length 1
Specifies one of the bar code lengths for DotCode. Length 1 is the minimum
label length if in
Variable Length on page 180
, or the first fixed length if in
Fixed
Length on page 180
. Characters can be set from 0001 to 9999 characters
(default: 1) in increments of 0001 (pad with zeroes). Always use four digits
(e.g.:
scan the barcodes
'0', '0', '0', '2' for setting length = 2). See "Set Length"
on
Chapter 4, References
for more detailed programming instructions.
Select DotCode Length 1 Setting
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code
at
left followed by the digits from the Alphanumeric
characters in
Appendix C
representing your desired
character(s). End by scanning the ENTER/EXIT bar
co
de again.
Make a mistake? Scan the CANCEL bar code to abort
and
not save the entry string. You can then start
again at the beginning.
CANCEL
0001 = Length 1 is 1 Character
To Next Page
Loading...
