Enter/Exit Programming Mode
Product Reference Guide 63
Flash On Time
This feature specifies the ON time for the indicator LED while in Flash Mode.
The selectable range is 100 to 9,900 milliseconds (0.1 to 9.9 seconds), in 100
millisecond increments. Always use two digits (e.g.: scan the barcode '0' and
the barcode '2' for setting 0.2 seconds). For more detailed programming
instructions, see "Flash On Time" on
Chapter 4, References
.
Select Flash ON Time Setting
To configure this feature, scan the ENTER/EXIT bar code
above, then the bar code at left followed by digits from
the Alphanumeric characters in
Appendix C
represent-
ing your desired character(s). End by scanning the
ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort and
not save
the entry string. You can then start again at the
beginning.
CANCEL
10 = Flash is ON for 1 Second
To Next Page
Loading...
