Enter/Exit Programming Mode
Product Reference Guide 203
Micro QR Code Set Length 1
Specifies one of the bar code lengths for Micro QR Code. Length 1 is the mini-
mum label length if in Va
riable Length Mode, or the first fixed length if in Fixed
Length Mode. Characters can be set from 0001 to 0035 characters in incre-
ments of 0001 (pad with zeroes). Always use four digits (e.g.:
scan the barcodes
'0', '0', '0', '2' for setting length = 2). For more detailed programming instruc-
tions see, "Set Length" on
Chapter 4, References
.
Select Micro QR Code Length 1 Setting
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code at
left followe
d by the digits from the Alphanumeric char-
acters in
Appendix C
representing your desired charac-
ter(s). End by scanning the ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort and
not save
the entry string. You can then start again at the
beginning.
CANCEL
0001 = Length 1 is 1 Character
To Next Page
Loading...
