Customizing Configuration Settings
Product Reference Guide 13
Interface Settings
The scanner is typically factory-configured with a set of default features stan-
dard to the interface type you
ordered. See
Using the DSM0400 on page 9
.
Configuration Using Bar Codes
provides settings configurable by all interface
types. If your installation requires you to further customize your scanner, you
c
an select other options through use of the instructions and programming bar
codes available in the appropriate section for your interface.
•
RS-232 ONLY Interface, starting on page 17
•
USB Keyboard ONLY Interface, starting on page 23
•
USB-OEM ONLY Interface, starting on page 51
Configuring Other Features
If your installation requires different programming than the standard factory
default settings, the following sections of this manual allow configuration of
non-interface-specific settings you might require:
Configuration Using Bar Codes
:
General Features includes programming for scan-
ning, speaker and LED indicators and other such universal settings.
Reading Parameters
:
Reading Parameters include programming for scanning,
speaker and LED indicators and other universal settings.
2D Symbologies
:
Includes options concerning the bar code label types (symbolo-
gies). These settings allow you to enable/disable symbologies, set label
le
ngths, require check digit, etc.
Software Version Transmission
The software version of the device can be transmitted over the RS-232, Key-
board and USB interfaces by sca
nning the following label.
Transmit Software Version
Resetting the Product Configuration to Defaults
If you aren't sure what programming options are in your scanner, or you've
changed some options and want to restore the Default Configuration, scan the
Restore Default Configuration
bar code below. This will restore the factory config-
uration for the currently active interface.
NOTE
Defaults are based on the interface type. Configure the scanner for the
correct interface before scanning this label.
To Next Page
Loading...
Need help?
General
