Enter/Exit Programming Mode
182 DSM0400 Fixed Mount Area Imager Bar Code Reader
DotCode Set Length 2
This feature specifies one of the bar code lengths for DotCode. Length 2 iis the
minimum label length if in
Variable Length on page 180
, or the first fixed length if
in
Fixed Length on page 180
. Characters can be set from 0001 to 9999 characters
(default: 7000) in increments of 0001 (pad with zeroes). Always use four digits
(e.g.: scan the barcodes '0', '0', '0', '2' for setting length = 2). See "Set Length"
on
Chapter 4, References
for more detailed programming instructions.
Select DotCode Length 2 Setting
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code
at
left followed by the digits from the Alphanumeric
characters in
Appendix C
representing your desired
character(s). End by scanning the ENTER/EXIT bar
co
de again.
Make a mistake? Scan the CANCEL bar code to abort
a
nd not save the entry string. You can then start
again at the beginning.
CANCEL
7000 = Length 2 is 7000
Characters
DEFAULT
To Next Page
Loading...
