Enter/Exit Programming Mode
Product Reference Guide 189
Maxicode Set Length 2
This feature specifies one of the bar code lengths for Maxicode. Length 2 is the
maximum label length if in Variable Length Mode, or the second fixed length if
in Fixed Length Mode. Characters can be set from 0001 to 0138 characters in
increments of 0001 (pad with zeroes). Always use four digits (e.g.: scan the
barcodes '0', '0', '0', '2' for setting length = 2). For more detailed programming
instructions see, "Set Length" on
Chapter 4, References
.
Select Maxicode Length 2 Setting
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code at
left followe
d by the digits from the Alphanumeric char-
acters in
Appendix C
representing your desired charac-
ter(s). End by scanning the ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
CANCEL
Length 2 is 0138 Characters
DEFAULT
To Next Page
Loading...
Need help?
General
