Enter/Exit Programming Mode
Product Reference Guide 179
Data Matrix Set Length 2
This feature specifies one of the bar code lengths for Data Matrix. Length 2 is
the maximum label length if in Variable Length Mode, or the second fixed
length if in Fixed Length Mode. Characters can be set from 0001 to 3,116 char-
acters in increments of 0001 (pad with z
eroes). Always use four digits (e.g.:
scan the barcodes '0', '0', '0', '2' for setting length = 2). For detailed program-
ming instructions see, "Set Length" on
Chapter 4, References
.
Select Data Matrix Length 2 Setting
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code at
left followe
d by the digits from the Alphanumeric char-
acters in
Appendix C
representing your desired charac-
ter(s). End by scanning the ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort and
not save
the entry string. You can then start again at the
beginning.
CANCEL
Length 2 is 3,116 Characters
DEFAULT
To Next Page
