Configuration Using Bar Codes
16 DSM0400 Fixed Mount Area Imager Bar Code Reader
Symbology-specific parameters:
"2D Symbologies" on page 162
defines options for all symbologies and provides
the programming bar codes necessary for configuring these features.
NOTE
You must first enable your scanner to rea
d bar codes in order to
use this section. If you have not done this, go to
Setup, starting on
page 5
and complete the appropriate procedure.
To program features:
1. Scan the ENTER/EXIT PROGRAMMING MODE bar code, available at the top
of each programming page, when applicable.
2. Scan the bar code to set the desired programming feature. You
may need
to cover unused bar codes on the page, and possibly the facing page, to
ensure that the scanner reads only the bar code you intend to scan.
3. If additional input parameters ar
e needed, go to
Appendix C
, and scan the
appropriate characters from the keypad.
NOTE
Additional information about many features can be found in
Chapter
4, "References"
.
If you make a mistake before the last character,
scan the CANCEL bar
code to abort and not save the entry string. You can then start again
at the beginning.
4. Complete the programming sequence by scanning the ENTER/EXIT PRO-
GRAMMING MODE bar code to
exit Programming Mode.
For more detailed descriptio
n, programming information and examples for set-
ting selected configuration items, see
Chapter 4, References
.
To Next Page
Loading...
Need help?
General
