Dell Force10 S2410-01-10GE-24P - Page 184

184 | Security Commands
www.dell.com | support.dell.com
Syntax
[no] port-security
Default
Disabled
Modes
Global Config; Interface Config; Interface Port Channel Config; Interface Range, which is indicated by
the (conf-if-range-interface)# prompt, such as (conf-if-range-vlan 10-20)#.
Command
History
port-security mac-address
This command adds a MAC address to the list of statically locked MAC addresses.
Syntax
port-security mac-address mac-addr 1-3965
The no port-security mac-address mac-addr 1-3965 command removes the MAC address
from the list of statically locked MAC addresses
The value represented by 1-3965 is a VLAN ID with a range of integers from 1 to 3965.
Mode
Interface Config; Interface Port Channel Config; Interface Range, which is indicated by the
(conf-if-range-interface)# prompt, such as (conf-if-range-vlan 10-20)#.
Command
History
port-security mac-address move
This command converts dynamically locked MAC addresses to statically locked addresses.
Syntax
port-security mac-address move
Mode
Interface Config; Interface Port Channel Config; Interface Range, which is indicated by the
(conf-if-range-interface)# prompt, such as (conf-if-range-vlan 10-20)#.
Command
History
Version 2.5.1 Modified: Added Interface Port Channel Config mode.
Version 2.3 Added Interface VLAN and Interface Range modes.
Related
Commands
interface Identifies an interface and enters the Interface Config mode.
interface range Defines an interface range and accesses the Interface Range mode
Version 2.5.1 Modified: Added Interface Port Channel Config mode.
Version 2.3 Added Interface Range mode.
Related
Commands
interface range Defines an interface range and accesses the Interface Range mode
Version 2.5.1 Modified: Added Interface Port Channel Config mode.
Version 2.3 Added Interface Range mode.
Related
Commands
interface range Defines an interface range and accesses the Interface Range mode