Dell Force10 S2410-01-10GE-24P - Page 185

Security Commands | 185
port-security max-dynamic
This command sets the maximum of dynamically locked MAC addresses allowed on a selected
interface.
Syntax
port-security max-dynamic maxvalue
The no port-security max-dynamic command resets the maximum of dynamically locked
MAC addresses allowed on a selected interface to its default value.
The
maxvalue range is from 0 to 600.
Default
600
Mode
Interface Config; Interface Port Channel Config; Interface Range, which is indicated by the
(conf-if-range-interface)# prompt, such as (conf-if-range-vlan 10-20)#.
Command
History
port-security max-static
This command sets the maximum number of statically locked MAC addresses allowed on a selected
interface.
Syntax
port-security max-static maxvalue
Use the no port-security max-static command to reset the maximum of statically locked
MAC addresses allowed on a selected interface to its default value.
The
maxvalue range is from 0 to 20.
Default
20
Mode
Interface Config; Interface Port Channel Config; Interface Range, which is indicated by the
(conf-if-range-interface)# prompt, such as (conf-if-range-vlan 10-20)#.
Command
History
Version 2.5.1 Modified: Added Interface Port Channel Config mode.
Version 2.3 Added Interface Range mode.
Related
Commands
interface range Define an interface range and access the Interface Range mode.
port-security max-static Set the maximum number of statically locked MAC addresses allowed on a
selected interface.
Version 2.5.1 Modified: Added Interface Port Channel Config mode.
Version 2.3 Added Interface Range mode
Related
Commands
interface range Defines an interface range and accesses the Interface Range mode