D-Show Profile Guide54
Snapshot General Preferences
The following settings are available in the Snapshots page.
Default Crossfade Time Defines the length of time it takes
D-Show to crossfade between fader levels when recalling snap-
shots. Maximum crossfade time is 99.9 seconds.
Center Last Recalled Snapshot Manages the display of the
Snapshots list so that the last recalled snapshot is always cen-
tered vertically, letting you maintain display of adjacent snap-
shots in the list.
PRE
The options in the PRE section let you specify which parame-
ters are recalled with Snapshots whose scope includes Pre set-
tings. Click to toggle whether recalled Input snapshot data in-
cludes the following:
• Gain, Pad, and Phase
• +48V (phantom power)
•HPF
Aux Mon and Aux FX
These settings let you classify individual Aux Sends or Variable
Group Sends (or linked bus pairs) as monitor sends (“Mon”) or
as effects sends (“FX”), which lets you scope each type sepa-
rately from the Snapshots page.
This option is for organizing Aux Sends and Variable Group
Sends for snapshot control only, and does not directly affect
Aux bus or Variable Group bus operation.
MTC (MIDI Time Code)
The MIDI Time Code options let you control MTC operational
modes, frame rate, and Start Time.
Modes Available MTC modes are MTC Off, MTC Read (slave),
and MTC Generate (master).
Frame Rate This option sets the frame rate that is used when
generating MTC.
Start Time This option sets the start time that is used when
generating MTC.
MIDI
Designates the channel on which snapshots send or receive
MIDI Bank Select and Program Change information.
Snapshots Send on Channel This option sets snapshots to send
Bank Select and Program Change commands on a selected
MIDI channel. This provides a quick and easy way to send a
MIDI command every time a snapshot is fired, without having
to embed a MIDI program change within each snapshot.
Snapshot Send on Channel does not need to be turned on in
order to send other types of MIDI data that are embedded in
snapshots, such as note on/off or MMC.
Snapshots Respond to Channel This option sets snapshots to
respond to incoming Bank Select and Program Change com-
mands on the selected MIDI channel.
MIDI Snapshot Output Safe Safes (shuts off) D-Show MIDI out-
put when snapshots are recalled. This does not affect sending
of Bank Select and Program Change commands with the
Snapshots Send on Channel option.
Misc
The Miscellaneous page provides utility and other settings.
Oscillator
Lets you choose the tone, frequency, and level for the built-in
oscillator.
While the Oscillator is set to Variable Sine, pressing the Osc
encoder momentarily changes the Osc encoder function from
level to frequency.
System Clock
Sets the date and time for the system.
Time of Day in Status Display
You can choose to show time of day in the lower right corner
of the screen in the Status display area. This optional display
can be configured for either 12 hour (AM/PM) or 24 hour for-
mat as follows:
See Chapter 21, “Snapshots.”
Delay is stored as a unique (discrete) data type for each
channel.
See Chapter 23, “Synchronization.”
Misc tab of the Options page
To Next Page
Loading...
Need help?
General
