User’s Manual
66
2.
Check
the
box
in
front
of
<AngelEye
M
ode>
to
display
AngelEye
m
ode
when the Emap window starts up.
3. Check the last item and input duration of time in seconds to display regular
Emap mode for the specified time and then switch to AngelEye mode
automatically.
Change Emap Size (Regular Emap Mode Only)
Users can adjust the display size of the map by clicking
on the icons shown on the right. The descriptions of the
icons are as below.
<Original>: To display the original size of the image.
<Double>: To double the size of current displayed image.
<Half>: To reduce current displayed image size by one half.
<Fill>: To adjust the image to fit display window (refer to figure on the right).
NOTE: If there is no map loaded in the Emap window, an error
message will be shown when clicking on any of the four buttons.
NOTE: When the map is very large, or when users cannot see the
entire map, click on any camera in the site tree and Emap will
automatically move to the location of the selected camera.
Ok / Cancel
Click on the <Ok> button to save all actions in the Emap window and exit.
Alternatively, click on the <Cancel> button to delete actions of this operation
and exit.
NOTE: If users try to close the Emap window by clicking on <X> at the
top, a hint message will be displayed to confirm if users wish to save
the setting.
To Next Page
Loading...