3 Installation
3.6 Motor feeder
108 Rapid Link 5 · RAMO5 · RASP5 05/20 MN034004EN www.eaton.com
On motor cables without the conductors for pins 5 and 8 (e.g., 4-core motor
cables) the pin 5 and pin 8 connections must be connected directly in the
motor plug. In this case, T1 and T2 in the motor terminal box are connected
with a separate cable and connected to an external monitoring device (e.g.,
EMT6).
Monitoring is performed depending on the setting in parameter P2-27.
3.6.2.3 Motor cable with connection for motor brake
In motors with attached, mechanical spring-loaded brakes, the control unit of
the brake can be controlled by RAMO5 or RASP5 depending on the type
using the following voltages.
Table 21: Control with RAMO5
Table 22: Control with RASP5
The connection is made using pin 4 and pin 6 in the motor plug
( Page 105)
Figure 66: General connection with brake
Type
Control section
RAMO5-xxx1… 180 V
RAMO5-xxx2… 230 V
RAMO5-xxx4… 400 V
Type Control section
RASP5-xxx1… 180 V
RASP5-xxx2…
230 V
RASP5-xxx4… 400 V
1746 3PE
M
3 ∼
PEWVUB1B2
58
T2T1
To Next Page
Loading...
