Eaton Rapid Link 5 - Configuration of Specific Settings; Commissioning

6 RASP5 speed controller
6.7 Configuration of specific settings
146 Rapid Link 5 · RAMO5 · RASP5 05/20 MN034004EN www.eaton.com
6.7 Configuration of specific settings
6.7.1 Commissioning
Before commissioning the RASP5 speed controller, the functions must be
set using parameters. The screw plug must be opened to adjust the parame-
ters.
Figure 88: RJ 45 interface
The parameterization can be done via :
• drivesConnect software
• Keypad
• drivesConnect mobile app
ATTENTION
The RJ45 interface is not designed for Ethernet communication.