3 Installation
3.3 Electrical installation
90 Rapid Link 5 · RAMO5 · RASP5 05/20 MN034004EN www.eaton.com
3.3 Electrical installation
3.4 Power bus
The Rapid Link 5 system can have one of two types of power bus:
• Flexible (RA-C1-7…) busbar,
• Round conductor (standard cable).
DANGER
Risk of injury due to electric shock!
Carry out wiring work only if the unit is de-energized.
ATTENTION
Fire hazard!
Only use cables, circuit breakers and contactors with the indica-
ted permissible nominal current value.
DANGER
The components in the RASP5 power section remain energized
up to five minutes after the supply voltage has been switched
off (internal DC-Link capacitor discharging time).
On RASP5 units, only disconnect the motor feeder cable and
only perform work on the motor terminal box after the dischar-
ging time has elapsed.
To Next Page
Loading...
