Eaton Rapid Link 5 - Parameter Group 5 (Communication)

8 Parameter list
8.3 Parameter groups for RAMO5
Rapid Link 5 · RAMO5 · RASP5 05/20 MN034004EN www.eaton.com 173
8.3.5 Parameter group 5 (Communication)
Table 38: Parameter group 5 (Communication)
Para-
meter
Designation Description Unit Min Max DS
P5-01 RS485-0 Address Unique address of the drive (keypad, OP bus) – 1 63 1
P5-02 COM Loss Timeout With an active communication link, if a valid telegram is not
received by the drive within the period set with this parameter, the
drive will react as set in P5-03.
s 0 5.0 2
P5-03 Action@Communication Loss Device reaction after "Communication Loss" occurs. Possibilities
device dependent
0: Trip
1: reserved
2: Stop
– 0 2 0
P5-05 NETSendPZD3 Configuration of the 3rd process data word PDO-3 from the drive to
the network master during cyclic communication.
0: Motor current in A with one decimal place, e.g. 100 ≙ 10.0 A
1: Output power in kW with two decimal places,
e.g. 400 ≙ 4.00 kW
2: Status of the sensor inputs (SEN I).
Bit 0 = status SEN I1, bit 1 = status SEN I2, etc.
– 0 6 0
P5-06 NETSendPZD4 Configuration of the 4th process data word PDO-4 from the drive to
the network master during cyclic communication.
0: Motor current in A with one decimal place, e.g. 100 ≙ 10.0 A
1: Output power in kW with two decimal places,
e.g. 400 ≙ 4.00 kW
2: Status of the sensor inputs (SEN I).
Bit 0 = status SEN I1, bit 1 = status SEN I2, etc.
– 0 6 1
P5-07 NETReceivePZD3 Configuration of the 3rd process data word PDI-3 from the network
master to the drive during cyclic communication.
0: reserved
– 0 3 0
P5-08 NETReceivePZD4 Configuration of the 4th process data word PDI-4 from the network
master to the drive during cyclic communication.
0: reserved
– 0 3 0
P5-10 Disable QuickStop 0: Quick stop via sensors deactivated
1: Quick stop via sensors activated; AS-i signal active
– 0 1 0