Eaton Rapid Link 5 - Commissioning

9 Communication
9.2 EtherNet / IP
220 Rapid Link 5 · RAMO5 · RASP5 05/20 MN034004EN www.eaton.com
9.2.13 Commissioning
 First carry out all the measures for commissioning the Rapid Link 5
module described in the previous chapter.
 Check the settings and installations for the switching on the EtherNet/IP
fieldbus system that are described in this manual.
ATTENTION
Ensure that no danger will be caused by starting the motor.
Disconnect the driven machine if an incorrect operating status is
causing a hazard.