Eaton Rapid Link 5 - LED Indicators

6 RASP5 speed controller
6.6 LED indicators
144 Rapid Link 5 · RAMO5 · RASP5 05/20 MN034004EN www.eaton.com
6.6 LED indicators
The LED indicators of the RASP5 speed controller display the operating sta-
tes and allow problems to be quickly diagnosed.
LED Display Description
FWD Clockwise rotating field of motor voltage (U–V–W)
Off Not actuated
Green enabled (RUN-Mode)
Flashing
(green)
controlled:
• But inhibited by the Quick stop function of the sensor inputs
• But blocked because when the supply voltage was switched on
(400 V or ASi), the key switch was in the MANUAL position.
￫ A Reset command required.
• STO signal present (inhibit)
REV Counterclockwise rotating field of motor voltage (W–V–U)
Off Not actuated
Green enabled (RUN-Mode)
Flashing
(green)
controlled:
• But inhibited by the Quick stop function of the sensor inputs
• But blocked because when the supply voltage was switched on
(400 V or ASi), the key switch was in the MANUAL position.
￫ Reset command required.
• STO signal present (inhibit)
AS-I AS-Interface
Data
Off ASi electronics have no supply voltage:
￫ Check ASi connection cables
￫ Check ASi power supply unit (master control)
Green Communication active, normal operation
Red No communication:
• Head-end controller (master) in STOP mode.
• RASP5 not entered or entered with the wrong address (ID).
• RASP5 in Reset mode.
Yellow flas-
hing, red
ASi address = 0
￫ Adjust ASi address
Green,
Red flashing
￫ fatal peripheral error; internal ASi error
Fault
Red No data exchange, communication error
Red flashing Peripheral fault,
I1 Sensor input I1
Off • not connected
• Not triggered (no input signal)
Green SEN I1 triggered (input signal)
REV OFF FWD
PWR FLT
AS-I
Data
Fault
OFF/RESET
SEN I1/I3
I1
SEN I2/I4
I2
I3
I4
STO
FAN