Eaton Rapid Link 5 User Manual

9 Communication
9.1 A S - In t er fa ce
Rapid Link 5 · RAMO5 · RASP5 05/20 MN034004EN www.eaton.com 201
9.1.14 Diagnostics and troubleshooting via the AS-Interface
All faults identified are transmitted to the AS-Interface assembly as group
fault messages: DI = 0 (Low). The FLT LED lights up red.
 Turn the key switch to the OFF position to reset the error message.
Hold the switch in this position for at least one second so that the
RAMO5 unit will detect the command.
The Reset signal from ASi provides an additional reset option in case the unit
cannot be locally reset due to accessibility issues. The local reset via the
keyswitch remains the main application, as each diagnosis has a cause that
needs to be analyzed and eliminated on-site.

Eaton Rapid Link 5 Specifications

General

Brand	Eaton
Model	Rapid Link 5
Category	Industrial Equipment
Language	English