8 Parameter list
8.4 Parameter groups for RASP5
Rapid Link 5 · RAMO5 · RASP5 05/20 MN034004EN www.eaton.com 185
8.4.4 Parameter group 3 (Mechanical brake and digital inputs)
Table 43: Parameter group 3 (Mechanical brake and digital inputs)
Parameter Designation Description Unit Min Max DS
P3-01 Brake mode Control of the mechanical brake
0: Simple mode (P3-02, P3-03)
1: extended mode (P3-02 to P3-05)
– 0 1 0
P3-02 Brake f-open Frequency limit at which the external brake is opened.
Condition: RUN (start enable)
Hz/rpm 0 P1-01 1.5
P3-03 Brake f-close Frequency limit at which the external brake is closed. Hz/rpm 0 P1-01 1
P3-04 Brake M-Level
Release
Required motor torque level at which the brake may be
released.
Determines the torque in % of the rated motor torque, which
has to be present before the mechanical brake may be
released. It is used to ensure that the motor is connected and
produces sufficient torque to prevent the load dropping on
release of the mechanical brake.
This function is not active in V/f mode (P6-01 = 6)
A 0 P1-07 0
P3-05 Brake release delay Determines the time before the mechanical brake is
released.
s 0 320 0
P3-06 SEN I1 Logic 0: normally open
1: normally closed
Note:
Change only after POWER ON / OFF active
– 0 1 0
P3-07 SEN I2 Logic 0: normally open
1: normally closed
Note:
Change only after POWER ON / OFF active
– 0 1 0
P3-08 SEN I3 Logic 0: normally open
1: normally closed
Note:
Change only after POWER ON / OFF active
– 0 1 0
P3-09 SENI4 Logic 0: normally open
1: normally closed
Note:
Change only after POWER ON / OFF active
– 0 1 0
P3-11 t-dec Select B0 Selection deceleration ramp bit 0
External stop function
0: deactivated
1: activated
– 0 1 0
To Next Page
Loading...
