Eaton Rapid Link 5 - Ethernet;Ip Interface of the Rapid Link 5 Module

9 Communication
9.2 EtherNet / IP
Rapid Link 5 · RAMO5 · RASP5 05/20 MN034004EN www.eaton.com 205
9.2.3 EtherNet/IP interface of the Rapid Link 5 module
An M12 plug is used to establish a connection to the EtherNet/IP field bus.
The following figure shows the EtherNet/IP interface of the Rapid Link 5
module with two M12 sockets.
Figure 111: EtherNet/IP interface
Generally, connection cables with M12 plugs for EtherNet/IP are available as
standard ready-to-use cables. They can also be prepared individually.
This will require the connections shown below (Observe pin assignment!).
Figure 112: Pin assignment E/IP P1 AND E/IP P2
1TD+
2RD+
3TD-
4RD-
5 
1
3
2
4
5