1 Rapid Link 5 system
Rapid Link 5 · RAMO5 · RASP5 05/20 MN034004EN www.eaton.com 11
1 RapidLink5 system
Rapid Link 5 is a modern, efficient drive and automation system.
Customer-specific and sector-specific requirements for material handling
systems are the main focus of the innovative Rapid Link 5 system design.
It is suitable for both simple and complex tasks in all areas of conveyor tech-
nology.
The Rapid Link 5 system allows electrical drives to be installed and put into
operation much more quickly and cost-efficiently than conventional, central
methods.
Thanks
to a power bus and a
data bus that are
plugged into every Rapid Link 5
module, the system is quick and easy to install.
The devices of the Rapid Link 5 system are available as customized solutions
• Electronic DOL and reversing starter RAMO,
• RASP5 frequency-controlled speed controller.
The following versions are available:
• Communication:
• AS-Interface
• EtherNet/IP
• Brake control voltage:
• 180/207 V DC
• 230/ 277 V AC
• 400/ 480 V AC
• Repair switches
• Brake resistor
• Safe Torque Off (STO)
• Power plug:
• HAN Q5
• HAN Q4/2
To Next Page
Loading...
