Eaton Rapid Link 5 - 7 Parameterization

7 Parameterization
Rapid Link 5 · RAMO5 · RASP5 05/20 MN034004EN www.eaton.com 155
7 Parameterization
The following section contains special information on configuring the
Rapid Link 5 module in order to adapt it to your requirements.
A change of the parameter values requires a connection with the RJ45
socket. The socket is located under the screw plug on the front.
Connection and configuration options
1. Connect the module to the PC using the DX-COM-STICK3 KIT
Bluetooth stick or the DX-CBL-PC-3M0 connection cable.
Figure 94: Connection using the DX-COM-STICK3-KIT Bluetooth stick
Figure 95: Connection using the DX-CBL-PC-3M0 parameterization cable
drivesConnect
Parameter&Edi
tor
D
r
iv
e&Control&/&Monitor
Function&Block&Editor
Scope&/&D
a
ta&Logger
&
R
e
a
d
y
USB
RJ45
RJ45
DX-CBL-PC-3M0
3.4 m (
11.15 ft)