Eaton Rapid Link 5 - 8 Parameter list; 8.1 Parameter Groups

7 Parameterization
7.2 Parameterization using OLED operating unit
Rapid Link 5 · RAMO5 · RASP5 05/20 MN034004EN www.eaton.com 161
7.2.1 DX-KEY-OLED operating unit elements
Table 30: Elements (buttons) of the DX-KEY-OLED operating unit
Button Command
Explanation
OK • Navigating in parameter mode
• Opens and closes the parameter interface
(Press and hold the button for more than two seconds)
• Saves parameter changes
START
• Parameter selection
STOP
• Reset – Reset after an error message
UP
• Increment numeric value or parameter number.
DOWN
• Decrement numeric value or parameter number.