Eaton Rapid Link 5 - 3 Installation; Introduction; Instruction Leaflets

3 Installation
3.1 Introduction
Rapid Link 5 · RAMO5 · RASP5 05/20 MN034004EN www.eaton.com 81
3 Installation
3.1 Introduction
This chapter describes the installation and electrical connection of
Rapid Link 5 modules RAMO5 and RASP5.
3.2 Instruction leaflets
The installation instructions in this manual apply to RAMO5 and RASP5 units
with standard equipment and IP65 protection class.
Refer to the appropriate RAMO5 or RASP5 instruction leaflets for the
required installation instructions.
Instruction leaflet for RAMO5:
• IL034084ZU
• IL034092ZU (variant “EtherNet/IP”)
Instruction leaflet for RASP5:
• IL034085ZU
• IL034093ZU (variant “EtherNet/IP”)
￫
During installation and mounting, cover or tape over the plug-in
connectors in the control and power sections to prevent foreign
bodies from entering them.
On RASP5 units it is also advisable to protect the cooling fins
and, if fitted, the fan from ingress of foreign bodies.
￫
Perform all installation work using only the specified, proper
tools and without the use of excessive force.