Eaton Rapid Link 5 - General Design Data of the Ethernet;Ip Interface

9 Communication
9.2 EtherNet / IP
Rapid Link 5 · RAMO5 · RASP5 05/20 MN034004EN www.eaton.com 219
Service codes
The following standard EtherNet/IP service codes are used in accordance
with the CIP Specification:
Identity object 01h
The 01h identity object provides information about the EtherNet/IP module.
This includes information regarding the device name, the device version, the
serial number, and version information.
Instance attributes for the identity object 01h
9.2.12 General design data of the EtherNet/IP interface
Service code Service name
0x0E Get_Attribute_Single
0x10 Set_Attribute_Single
0x4E Read_Holding_Registers
0x50 Write_Holding_Registers
0x18 Get_Member
0x19 Set_Member
Attribute
number
Attribute name Access
right
ro | rw
Data type Description
1 (0x01) VENDOR ro UINT Manufacturer’s code
2 (0x02) DEVICE TYPE ro UINT Classifies the product as a communica-
tion adapter
3 (0x03) PRODUCT CODE ro UINT Order number
4 (0x04) REVISION
MAJOR
MINOR
ro STRUCT of
USINT
USINT
Device version
5 (0x05) DEVICE STATUS ro WORD Device status
6 (0x06) SERIAL NUMBER ro UINT Serial number of the device
7 (0x07) PRODUCT NAME ro SHORT STRING Length (first byte) and product name
Property Value
Connections M12 D-coded
Data transfer 10/100 Mbit/s
Full-duplex/half-duplex automatic baud rate detection
Transmission cable
Twisted two-pair balanced cable, screened
Communication protocol
Standard IEC 61158
Baud rate 10/100 Mbit/s