Eaton Rapid Link 5 - Page 171

8 Parameter list
8.3 Parameter groups for RAMO5
Rapid Link 5 · RAMO5 · RASP5 05/20 MN034004EN www.eaton.com 167
P0-26 kWh Meter Energy consumption kWh Meter (not resettable)
Displays the energy consumption in kWh.
When the value reaches 1000, it is reset to 0 and the number of MWh in P0-27
is increased by 1.
The value cannot be reset and shows together with P0-27 the energy
consumption since the day of manufacture.
kWh
P0-27 MWh Meter Energy consumption MWh Meter (not resettable)
Displays the energy consumption in MWh.
The value cannot be reset and shows together with P0-26 the energy
consumption since the day of manufacture.
MWh
P0-28 Application Version Application Version
Level 1: Application version + checksum
Level 2: System version + checksum
–
System Version System version –
P0-29 – Device information –
NoOfInputPhases Number of input phases
FrameSize Frame size
kW/HP Motor Power
Power@Ue Device Power at Device Voltage Rating
Device Voltage Device Voltage Rating
DeviceType Device type
P0-30 Serial Number Serial Number of the device –
P0-31 t-Run Total operating time of the drive since the date of manufacture
Displayed in hours, minutes and seconds.
Pressing Δ on the drive keypad will change the display from “hours” to
“minutes and seconds”.
hh:mm:ss
P0-32 t-Run since Restart Run time since power on or last Reset
Total operating time of the drive since the last trip occurred or power down in
hours, minutes and seconds.
Pressing Δ on the drive keypad will change the display from “hours” to
“minutes and seconds”.
hh:mm:ss
P0-33 t-Run since Trip Total operating time of the drive since the last trip occurred
Displayed in hours, minutes and seconds.
Pressing Δ on the drive keypad will change the display from “hours” to
“minutes and seconds”.
hh:mm:ss
P0-34 t-HoursRun Enable Total operating time of the drive since the last drive ENABLE signal was
applied
Displayed in hours, minutes and seconds.
Pressing Δ on the drive keypad will change the display from “hours” to
“minutes and seconds”.
hh:mm:ss
P0-36 DC-Link Log DC-Link voltage log
Displays the most recent 8 samples of the DC bus voltage prior to a drive trip
condition occurring.
The sample interval is 256 ms.
V
P0-39 AmbientTemp Log Internal Ambient Temperature Log
Displays the most recent 8 samples of the internal ambient temperature prior
to a drive trip condition occurring. The sample interval is 30 s.
°C
Para-
meter
Designation Description Unit