Eaton Rapid Link 5 - Page 219

9 Communication
9.2 EtherNet / IP
Rapid Link 5 · RAMO5 · RASP5 05/20 MN034004EN www.eaton.com 215
The program will show you all available modules.
Figure 121: Select the station
 Select the station on the right-hand side (RASP5).
 Now click on the 0xF5 TCP/IP tab.
Figure 122: The 0xF5 TCP/IP tab
 Select Interface configuration (attr 5) > Get attribute.
The current IP address will be displayed.
Figure 123: The current IP address
 Now set an IP address.
 Confirm the information by clicking Set Attribute.
 You can now close the Molex program.