9 Communication
9.2 EtherNet / IP
Rapid Link 5 · RAMO5 · RASP5 05/20 MN034004EN www.eaton.com 217
You can:
• Change parameters (but not save them) to save the parameters,
parameter P2-36 must be set to 1.
• Read measured values and error registers
• Address and read out parameters via the RJ45 interface,
the parameterization software drivesConnect, and field buses.
• Control control level functions without the power section being
powered.
Status LED Description
Off External 24 V DC voltage not present
Green illuminating
External 24 V DC voltage present
To Next Page
Loading...
