Eaton Rapid Link 5 - Page 46

2 Engineering
2.3 Repair switches
42 Rapid Link 5 · RAMO5 · RASP5 05/20 MN034004EN www.eaton.com
The positions of the repair switch are shown in the illustration below.
In the case of RAMO5:
Figure 14: RAMO5 with repair switch
In the case of RASP5:
Figure 15: RASP5 with repair switch
Switch position 0 (= OFF) can be locked in place by pulling up the red padlock
locking collar.
If necessary, up to two padlocks with a 5 mm diameter bracket can be inser-
ted into the recess of the padlock locking collar.
After completion of maintenance or repair work, the switch can be released
again and returned to position I (= ON). The motor can then be restarted with
a start signal in manual or automatic mode.
0 = OFF
I = ON
⌀ = 5 mm 2 x
(⌀ = 0.20” 2 x)
⌀
0 = OFF
I = ON
⌀ = 5 mm 2 x
(⌀ = 0.20” 2 x)
⌀