2 Engineering
2.9 Sensor inputs
Rapid Link 5 · RAMO5 · RASP5 05/20 MN034004EN www.eaton.com 65
The input signals of the sensors at I1 and I2 are incorporated directly in the
internal controller of RAMO5 and RASP5 and transmitted to a higher-level
PLC through the AS
-
Interface. The signal adaptation and integration into the
controller sequence is carried out via parameter P1-13.
Figure 26: Connection to sensor inputs (RASP5 as an example)
S
EN I1/I3
A
S-I
Data
Fault
I
1
Q1
I4
I2
I3
S
EN I2/I4
STO
≦ 20 m
(≦ 65.6 ft)
1
2
To Next Page
Loading...
