Eaton Rapid Link 5 - Page 8

4 Rapid Link 5 · RAMO5 · RASP5 05/20 MN034004EN www.eaton.com
6 RASP5 speed controller............................................................. 135
6.1 Designation.................................................................................. 135
6.2 Features....................................................................................... 136
6.3 Connections................................................................................. 137
6.4 Specific technical data ................................................................. 138
6.4.1 Overload capacity......................................................................... 140
6.4.2 Derating curves............................................................................ 141
6.5 Block diagram .............................................................................. 142
6.6 LED indicators.............................................................................. 144
6.7 Configuration of specific settings ................................................ 146
6.7.1 Commissioning ............................................................................ 146
6.7.2 Set the rated motor current (P1-08)............................................. 147
6.7.3 Sensor inputs............................................................................... 148
6.7.4 Quick stop and interlocked manual operation.............................. 149
6.7.5 Phase change .............................................................................. 152
6.7.6 Motor cable monitoring................................................................ 152
6.7.7 Stop behavior............................................................................... 153
7 Parameterization........................................................................ 155
7.1 Configuration using the drivesConnect software......................... 158
7.2 Parameterization using OLED operating unit............................... 160
7.2.1 DX-KEY-OLED operating unit elements....................................... 161
7.2.2 Set parameters ............................................................................ 162
7.2.3 Reset parameters (RESET) .......................................................... 163
7.2.4 Extended parameter set .............................................................. 163
7.3 Configure parameters using an app............................................. 164