C
HAPTER
12
| General Commands
– 117 –
end This command returns to the previous configuration mode.
DEFAULT SETTING
None
COMMAND MODE
Global Configuration, Interface Configuration
EXAMPLE
This example shows how to return to the Configuration mode from the
Interface Configuration mode:
AP(if-ethernet)#end
AP(config)#
exit This command returns to the Exec mode or exits the configuration
program.
DEFAULT SETTING
None
COMMAND MODE
Any
EXAMPLE
This example shows how to return to the Exec mode from the Interface
Configuration mode, and then quit the CLI session:
AP(if-ethernet)#exit
AP#exit
(none) login:
cli-session-timeout This command enables a timeout for console and Telnet sessions.
SYNTAX
cli-session-timeout <enable | disable | value>
enable - Enables the timeout.
disable - Disables the timeout.
value - Sets a time for the timeout (Range: 60~3600 seconds).
DEFAULT SETTING
120 seconds
To Next Page
Loading...
Need help?
General
